Friday, October 18, 2019

Base Station Case

I finished the case for my base station.  I found an easy way to insert threaded nurled inserts into the plastic and then the PCBs can be attached with screws.

Incidentally, the base station receives LoRa packets from the sensor and posts them to the web using WiFi. 







The single button is for FOTA.  A single press on the recessed button/LED combo button requests it to go out the web and download my latest firmware.   It takes about 30s to load new firmware.





at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Tourbillon Project

Tourbillon Project I was interested to push the limits of 3D printing... basically for the hell of it, and to distract me from being indoors...

  • First Layer Calibration
    I've been generating a lot of print failures. Mostly they show up on the first layer, but some happen much later on. The...
  • OctoPrint - revised instructions
    OctoPrint - changing WiFi AP Plug an Ethernet wire into the RaspberryPi (hearafter RPi), and power it up.   Skip down to the section be...
  • FlashAIR - Success at last
    Scroll down to the "FlashAir 3rd attempt - success at last" Attempt #1  I found the SD card annoying.  It was easy to flip the...