Friday, October 11, 2019

Revising parameters

Temperature


After the first layer the fan turns on and drops the temp so low that it generates a "Thermal Runaway" error.  I changed the params as follows and got a better result


Partial printing

A couple of attempts resulted in prints that stopped short of producing a finished print.  I changed the printing quality to "0.15 OPTIMAL" and that seemed to fix that problem.


at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Tourbillon Project

Tourbillon Project I was interested to push the limits of 3D printing... basically for the hell of it, and to distract me from being indoors...

  • FlashAIR - Success at last
    Scroll down to the "FlashAir 3rd attempt - success at last" Attempt #1  I found the SD card annoying.  It was easy to flip the...
  • OctoPrint - revised instructions
    OctoPrint - changing WiFi AP Plug an Ethernet wire into the RaspberryPi (hearafter RPi), and power it up.   Skip down to the section be...
  • First Layer Calibration
    I've been generating a lot of print failures. Mostly they show up on the first layer, but some happen much later on. The...