Saturday, October 19, 2019

Supports/rafts & Shaun the Sheep

I printed Shaun the Sheep.  The first attempt collapsed because there were no supports under his head and belly.

The next attempt included rafts, but added two hours to the print time.
Shaun with supports

It took about 15 minutes to carefully remove all the supports.  Many snapped off easily leaving little behind, but a few had to be cut off.  Then I had to file off the rough remains.




at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Tourbillon Project

Tourbillon Project I was interested to push the limits of 3D printing... basically for the hell of it, and to distract me from being indoors...

  • First Layer Calibration
    I've been generating a lot of print failures. Mostly they show up on the first layer, but some happen much later on. The...
  • OctoPrint - revised instructions
    OctoPrint - changing WiFi AP Plug an Ethernet wire into the RaspberryPi (hearafter RPi), and power it up.   Skip down to the section be...
  • FlashAIR - Success at last
    Scroll down to the "FlashAir 3rd attempt - success at last" Attempt #1  I found the SD card annoying.  It was easy to flip the...