Saturday, October 12, 2019

PET (Ha)

This prints with a higher temp so I expected some issues.   It seemed to make a mess starting up.

 





The final results seems OK.
   


 

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Tourbillon Project

Tourbillon Project I was interested to push the limits of 3D printing... basically for the hell of it, and to distract me from being indoors...

  • First Layer Calibration
    I've been generating a lot of print failures. Mostly they show up on the first layer, but some happen much later on. The...
  • OctoPrint - revised instructions
    OctoPrint - changing WiFi AP Plug an Ethernet wire into the RaspberryPi (hearafter RPi), and power it up.   Skip down to the section be...
  • FlashAIR - Success at last
    Scroll down to the "FlashAir 3rd attempt - success at last" Attempt #1  I found the SD card annoying.  It was easy to flip the...